Wire Rope Tension meter 電纜鋼纜張力計 SY-600 / SY-1000

張力計； 其他固體物理量； 物性測定；

SY系列用於鋼簾線,高架線,拉力繩索,天線,電纜等張力的測定,也可用於控制和比較預拉伸得金屬絲的測量值, 最大線徑為20mm Ø

•大表盤，容易讀數 (100 mm Ø)

•堅固鋁製機身

測量原理:

1. 測量原理是基於精確測量電纜偏差,這種偏差是由於兩個U型槽內滑塊滑動過程中產生的力造成的

2. 電纜的張力值是由於測量偏差的精密表盤式指示器標出讀數

3. 測量結果是依據線徑(mm)和相對應的(daN)換算表得出的

4. 電纜測量長度於兩固定點間最小距離為5米

2 Tension ranges from 500 - 1500 daN up to 900 - 3000 daN

Mechanical wire rope tension meter to determine the tension of overhead lines, tensioning ropes, contact wires, aerials, etc. up to max. 20 mm Ø.

This hand-held unit is used for control and comparision measurement of pretensioned non running ropes.

Tension meter with large easy to read scale (100 mm Ø)

Special Features

< >Tension meter for rope diameters up to 20 mm Large easy to read scale (100 mm Ø)Standard Features

< >Rugged aluminium housingMeasuring Principle

With the two outer rollers, the device will be hooked into the strained rope. With a knurled screw, the middle roller will be brought in the measuring position. Operation is based on precisely measuring deflection, caused by the application of a force mid-way between two U-grooved pulley supports. Cable tensions are then determined by nothing the reading on a precision dial indicator that measures the deflection. The measuring result has to be converted from mm reading to the corresponding force in daN with the help of a conversion chart. The smalest rope length to be measured between two fixing points is 5 m.

Available Models

*Range and diameter can verify depending material and rope design

Specifications